![]() ![]() #define OTApassword "xxxxx" // change this to whatever password you want to use when you upload OTAĪnd my Configuration. #define light_set_topic "House/Backroom/set" #define light_state_topic "House/Backroom" #define wifi_ssid "VMxxxxxx" //type your WIFI information inside the quotes If someone could take a look it would be really appreciated i have not changed anything else from the original by Bruh, followed by my YAML file. Note: Electronic products sold in US store operate on (110-120) volts, a step-down power converter is required for the smooth device function. So here is the 1st part of the sketch for a sensor. I can control both of the switches from the front end of HASSIO so don’t think they are the problem. For the +12V Rail in the picture doing volts x amps gives you the correct number. In the picture ive attached i know the formula is (watts volts x amps). also i cannot get the LED’s to switch on, which may be related. Hi i just have a quick question on power supply voltages, its just out of interest. I think it must be something in my configuration. So have rolled back to 2.3 from 2.4.1 on board manager and still the same result. ![]() also tried connecting both to 2 different laptops and still they reboot. Emoshayoga Access Control Power Supply Box, 12V Output. just tried a pair of brand new Samsung phone chargers with 2.0 amp output. Input Voltage: 120 V AC 230 V AC Efficiency: 90.5 Input Voltage: 120 V AC 230 V AC Model : SDR-240-48. Thanks for replying, had already tried power supplies but thought i would try again. After back from dinner, I turned on the main switch, the back switch of XPS-1 in Sequence. #Boxee box power supply voltage code#The only thing I can think is either homeassistant is not liking PIR anymore (although my other PIR sensors are working fine) or something has updated in the arduino library prior to flashing the board that it doesnt like?Īny ideas? I will post my code tonight when I’m back home if anyone can help. Initially it is working fine for the first 2 hours and went for dinner after that. The MQTT topic for the board is fine since I have a reed switch on the same board which is displaying the state correctly.Īnyone else suddenly having PIR function not working as expected on new board flashes? I’ve tried a couple of different PIR modules, and tried swapping the pins around in the code just in case the node’s board was defected. ![]() It doesnt say either standby/motion detected its just blank. Got a few of these boards set up fine accross my house, but I’ve tried adding an aditional one with just a PIR sensor.Īfter using the exact same code, hardware and config.yaml(obviously changing the MQTT topics and unique bits) A board I’ve deployed is not showing the PIR state at all. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |